Out of Job 2

[Jeff Wohlt]

More stuff...see post one for details of payment, etc. These are prices which include S&H 1st class in the US

1 built Campbell Shovel with ridepads, hardware, bearings brass strut and fuller rudder and 2 each 062 wire drives. $95 (SOLD)

1 NEW Campbell Shovel Kit with frame to build $70

1 Grupner 5x4 mm flex coupler $6 (sold to HydroJerry)

5 each brass bullet nuts $3.50 each (SOLD)
3 each Kentic UL1 Motor Can coolers $11 each (2 left)

FLEX HEX Couplers

1 each 5mmx187 $14 (sold)
2 each 5mm x 150 Short Versions $14 each (1 left) (last sold to hydroJerry)
5 each 5mm x 150 long versions $14 each (1 sold 4 avail)
Flex hsafts pre-made with Octura shafts
2 each 3/16 x 130 flex shafts with 12" flex $10 (SOLD)
4 each 3/16 x 150 flex shaft with cables $11 each (sold)
2 each 3/16" shaft x 187 flex cable $12. (1 sold 1 avail)
I thhink that covers it now. Thanks to all of you who have supported me.

[HYDROJERRY]

hay is that 5mmx4mm flex coupler go from the motor 5mm to the flex shaft 4mm like in the 4th picture if so i need one...

[Jeff Wohlt]

Sure it can. Normally it would go from a 5mm motor shaft to a 4mm hard shaft. As long as you have the flex shaft supported and run it close to the stuffing tube so you get no slop.

[HYDROJERRY]

is it the 2nd picture

[line6]

PP sent on one 3/16 shaft .187 flex. One 3/16 shaft .150 flex & the 5 mm .187 coupler

thanks. Jason

[line6]

I need one more 3/16 shaft .150 flex

thanks agian. Jason

[johnnyoverkill]

Jeff,

I'll take the remaining 2 .150 Octura cables, and 2 .130's. PP is on its way.

John

[lectriglide]

Jeff,
Paypal sent for 1 each -
3/16 x 150 flex shaft with cables $11 each
5mm x 150 long versions $14 each
Thanks, George

[daveives]

Built Campbell Shovel

Paypal sent for 1 built Campbell Shovel with ridepads, hardware, bearings brass strut and fuller rudder and 2 each 062 wire drives. $95

[Jeff Wohlt]

Thanks, guys. I will process all of this and all should ship on WED.

[steveo]

how long are the .187 flex, what size tube does that work with - with out teflon liner

[Jeff Wohlt]

I think they are around 16" total. I would use a 7/32 stuffing tube with no liner

[Karfrik]

Darn!!!... I need(ed) one of those 3/16 x 130 flex shafts!!! if any more just shoot me a PM,.....Albert

[steveo]

i will take the .187 flex if it is 16" please let me know actual size, is that total length or to the stub shaft

thanks

[Chilli]

I'll take one of the UL1 Can coolers. PP sent.