UL-1 hull and hardware

[bustitup]

I know on the older hulls some guys have a precautionary fix and you said excellent so I was not exactly sure on the condition,I could not make it out on your pic sorry to bother you

No bother Sir....I thought I made it clear

GL

[BIGDG357]

Does the fiberglas need much repair?

[bustitup]

Does the fiberglas need much repair?

ok I will take a good picture for you but when I bought the boat I was told the turn fin area was not damaged at all....and it probably wasn't because i trust the member here but I have to say it was packaged very loosely and probably hit the turn fin and slightly broke the fiberglass where the turn fin bolts to the hull.......the fin is still bolted on the glass but moves a little bit....you could not run it like this would unbolt the bracket off of the boat and take a small piece of plywood (like 1/8" and bond it to the hull...then lay a layer of either glass or CF over it ......let dry and bolt the fin back on...I will include a small piece of cf to cover it

probably a couple hours of labor not counting drying time

the boat has no scratches or blemishes on the outside and the inside has a smoke stain on the lid from a burnt esc but will clean up with denatured achohol or oven cleaner

boat is worth $100 easy

[bustitup]

here is the crack...its an easy fix

the discoloration you see is from the camera flash....this boat is as red as a fire truck and no scratches or scrapes


guy from australia is very interested......first one to say they want..... it its theres

[longballlumber]

Is than an aftermarket strut, and has the stuffing tube been cut back?

Thanks
Mike

[bustitup]

yes aftermarket strut and it doesnt look like the tube was cut back at all...again the orange bloches are camera flash...this hull looks awesome
also you can see the homemade air damm that is easily removable

Is than an aftermarket strut, and has the stuffing tube been cut back?

Thanks
Mike

[bustitup]

$75 for the hull only?

[Jeepers]

$75 for the hull only?

Tempting but I have 4 hydros and a OPC to finish!

[bustitup]

Tempting but I have 4 hydros and a OPC to finish!

yes but just think...you could have #5 sitting on the shelf waiting for attention

[Cyberdan]

Hello,

waht about shipped to Canada including Hardware?

[bustitup]

Hello,

waht about shipped to Canada including Hardware?

I would say about an extra $35 to your country......unless someone here knows a cheaper way
paypal only

[6S HYDRO]

what r u doing with the cowlings

[bustitup]

I consider it part of the hull

[Cyberdan]

Is $125 possible to Canada (Hull and Hardware)?

[Cyberdan]

Is $125 including shipping to canada OK? (Hull and Hardware)