sport 20 turn fin

[teetriple]

WTB sport 20 size turn fin preferably a Virginia craftsmen but something similar would be good need it for my new LSH build checking with you guys in the club here first before I post some were else Thanks guys

[tjcast]

Talk to Pete. He should have a few of the ones TFL made for me. Not sure if he finished adjusting the curve on them (hint, hint Pete). If you want one we will talk price but I can assure you it will be a lot less then VC AND you won't have to wait 6-8 months

CIMG0023.jpg

[teetriple]

Sounds good to me tom thanks

[Shooter]

I sent them this morning. Should have them tomorrow. The first (3) used the 'old' method of bending which required some scotch brite to clean them up. The rest of them looked good out of the gate.

Give them a try. They may need more curve.

[T.S.Davis]

Tyler needs one too.

[teetriple]

Cool Pete I'll have to get one from Tom look forward to running with you guys again

[longballlumber]

Cool Pete I'll have to get one from Tom look forward to running with you guys again

Whatcha building?

[T.S.Davis]

Talk to Pete. He should have a few

A few? I heard it was approximately........a bunch more than a few.

Tony, I put one of these on my P Sport Whip. They can hold at terminal velocity.

[tjcast]

Thanks Pete. I'm sure they will be great

[teetriple]

Mike trying to build a whip 20 sure I'll have some questions for the guys in the club running them

[Shooter]

Just fyi. Freddy and I are heading to the RC clubhouse tomorrow (thurs) after lunch (taking a half day) to goof around. Going to be running 1/8th and 1/10th buggy.

[tjcast]

Where is the clubhouse located?

BTW the turn fins turned out GREAT!

Thanks Pete

[T.S.Davis]

Can I snag one of these at practice this evening? I'd like to get the stealth back on the water this weekend. Out of time.

[tjcast]

Planning on it

[Shooter]

Where is the clubhouse located?

BTW the turn fins turned out GREAT!

Thanks Pete

I think the 'old method' has slightly more curve to it. The new method (jamming a thin pc of al between the rollers) seemed to be more consistent from part to part, but slightly less curve. Should be interesting to see if they work.