Short Pursuit Video

[rhgraphix]

Here is a short video after my motor/esc/batt upgrades. More videos to follow!

http://youtu.be/R7OUWQLJek8

[lenny]

Hey,
Be very careful because that boat is running very wet.
That is why it is so hard to steer to,
Do you know what your temps were of the setup after a couple minutes of running ?
Just trying to save your setup from over working it's self.

I need to see some pictures of the hardware setting to.

[rhgraphix]

Hey,
Be very careful because that boat is running very wet.
That is why it is so hard to steer to,
Do you know what your temps were of the setup after a couple minutes of running ?
Just trying to save your setup from over working it's self.

I need to see some pictures of the hardware setting to.

Wet for sure... as always thanks for the input.

Those pics/video were before some tweaks on the trim tabs, etc. It turns really well now. I also need to do some tweaking to the drive as well.

I posted some pics on the other thread of my setup. Ran today and my temps were low (under 100) on the motor and batteries - on the esc it was 124. But it was 93 degrees when I was running in some warm water. Where I normally run it is the river very cool water there.

I am changing the prop to a M445 and going to do some more running later this week. Boat runs awesome though!!

[lenny]

Great,
Glad it is running good now.
The m445 should give you close to 5mph more speed,
I have been testing mine with a x447/3 prop and it runs pretty nice with it.
The three bladed prop work very well on mono and also help control torque roll some to.

[rhgraphix]

very cool. i will have to try one of those sometime.

[rhgraphix]

Tested the new M445 out yesterday. Temps stayed about the same. Hot day. Warm water. Rooster tail much lower.