My jae21fe

[Serpents811]

Here we go guys my jae21fe etti150amp ,leopard 3674 2200kv 4s1p maxamps 150c , 1450mod prop from Zippkits , it was radar at 55mph not to happy

http://www.youtube.com/watch?v=nydmDcIMeQo&feature=youtube_gdata_player

[HOTWATER]

Looks very good! ...have you tried an H-7 prop yet?

-Kent

[Serpents811]

Looks very good! ...have you tried an H-7 prop yet?

-Kent

Kent , that's a trl 1450 modded from Zippkits.com , I did try a full blade h7 and actually went slower
Having it cut down 46mm

[HOTWATER]

Send that H7 to Mark Sholund and have him put some "magic" on it...

[Serpents811]

Send that H7 to Mark Sholund and have him put some "magic" on it...

Actually I have to give him a call to make me a h5 prop for my new insane fe30

[HOTWATER]

Nice!

[steveo]

eww 55 mph that thing is a turd.........jk looks good i'd be satisfied

[dana]

55 isn't slow, but you should be in the 60's easy...I think... What speeds were you hoping for?

[Serpents811]

eww 55 mph that thing is a turd.........jk looks good i'd be satisfied

Thanks I know it really doesn't sound like much for the setup that I have in it but we'll make it there

[Serpents811]

55 isn't slow, but you should be in the 60's easy...I think... What speeds were you hoping for?

I'm was hoping for low 60's , how ever that was with radar gun and friends mean machine was tracked at 54mph with the radar later gps at 60.2mph with the same setup so I don't think the radar gun wasn't that accurate

[bigwaveohs]

Here we go guys my jae21fe etti150amp ,leopard 3674 2200kv 4s1p maxamps 150c , 1450mod prop from Zippkits , it was radar at 55mph not to happy

http://www.youtube.com/watch?v=nydmD...e_gdata_player

That large roost means you either have the strut set above the ski or you are getting too much lift from that prop. You need to keep the prop buried so all the thrust is forward with a small thrust cone...JMHO.
Pete

[jcald2000]

How are your batterys???
That does not sound like enough rpm.

[Serpents811]

How are your batterys???
That does not sound like enough rpm.

The battery is fine and everything is working as cool as it can be then again the water temps here are 40deg

[hebner]

I watched the video, I agree with jcald2000 it sounds like the motor is not seeing full throttle. You might need to adjust the throttle trim on the TX to be sure your getting 100% on the high side.

[Serpents811]

I watched the video, I agree with jcald2000 it sounds like the motor is not seeing full throttle. You might need to adjust the throttle trim on the TX to be sure your getting 100% on the high side.

i'll double check all my settings again just to make sure , anybody else out there with this setup what are the speed range and temps