Unlimited Hydroplane Size does matter

[heraldoboldrin]

where i can find 1/6 scale hydro?

[ManuelW]

http://www.youtube.com/watch?v=7rvzYgF28JE

http://www.youtube.com/watch?v=LfDUq16zowo

Probably the two best videos of FE powered HPR 233's.

Best regards,
Manuel

[properchopper]

Wanna nice biggie ?

http://www.radtekpowerboats.com/

http://www.youtube.com/watch?v=11KxNebPwGU

Biggies, Biggies,
buy 'em by the ton.
Spend a lotta' money
Have a whole lotta' fun

[T.S.Davis]

Full scale! hehe How many cells you figure that'll take Steve? I am not strapping my big behind to that.

[sjslhill]

Keep working on em boys, soon we can ride in one and have racing with real drivers....

[podagee]

wow that's some nice cat's

[Punisher 67]

I have to agree with the boys here , forget the inline set ups thats a wiring nightmare and forget any notion that two 5692's are going to do it for you . here is a size comparison between a chevy 305cid and the Bugati Veyrons W16 8.0Litre quad turbo motor................... The motors interior would spell an even larger difference and then comes the build quality and motor efficiency

5692 and a Lehner 3080

5692 rotor = 27mm x 50mm
3080 rotor = 30mm x 80mm

The second picture is a HPR 92" cat powered by twin Lehner 3080's , these hulls can approach close to 80+ mph if not faster and weigh in at over 70 pounds . So in reality there are guys out there running in that size bracket and doing it with electrics .

[jevmax]

Forget about in line connected brushless motors. Just run parallel drive lines. Two props. Two 3080-8s, etc. it will work great.

[T.S.Davis]

Did that in-line motor setup ever pan out? I keep thinking there's too much potential for a missfire with 4 ESC running independent of one another. Frishizzling a speedo seems imminent.

With a great big boat I would think you could run two separate drive lines. I mean "scale" is kind of irrelevant at this size.

Way back a thousand years ago Vasdekis built a Cyclone cat with 5 Aveox powered gear drives to 5 props. Had a 60 Nimh in it too. Terrifying setup. All those 4 pole motors and speedos winding up sounded like an alien spacecraft taking off.

[T.S.Davis]

Did that in-line motor setup ever pan out? I keep thinking there's too much potential for a missfire with 4 ESC running independent of one another. Frishizzling a speedo seems imminent.

With a great big boat I would think you could run two separate drive lines. I mean "scale" is kind of irrelevant at this size.

Way back a thousand years ago Vasdekis built a Cyclone cat with 5 Aveox powered gear drives to 5 props. Had a 60 Nimh in it too. Terrifying setup. All those 4 pole motors and speedos winding up sounded like an alien spacecraft taking off.

[larryrose11]

As far a multiple motors go, an OSE member put them in line, as in on a common shaft.
http://forums.offshoreelectrics.com/...highlight=quad

I know that some of the regular sized DIY Electric Vehicles do this, mainly for drag racing. Thye call it a Siamese motor

http://www.plasmaboyracing.com/index.php

[podagee]

Well I like being crazy and if it all works out then I'm sure there will be more boats this size in FE. If not well I can hang it in my garage and say wow nice boat. Yes I do have a truck and I Fly two 600 Trex Heli's one 500 Trex heli and three offroad cars and one onroad drifter. and thanks I'll keep that in mind about the 3080's. I want to keep it safe for everybody and namba only covers up to 60" boats so I may have to go with a 60" Hydro. I got the Plans from Newton and I didn't like it so I'm getting Plan 164 1994 Bud, But I'll paint it Bud light blue or something cool. I would like to stay with FE just because I've never seen one done that big. And with all the high tech motors we have now days there's gotta have a motor that can make a boat fly on water. Well I'll try it first, and if it do not work out then we'll all know that it can't work in FE. BUT if it works out see you at the race's.

[T.S.Davis]

OMG and make sure there are no other boats/people/critters on/in/and or around the pond you find big enough to run this. My testicals are too small to take on this kind of liability. That's just me though. I'm kind of a negative nancy.

Twin 3080 ($1600?), Thunderpower G6 10s/10000 x 2 ($1400?), 2 schulze 40/160 ($1500?) = $4500 before you've bought any hardware. All for a "might/should/could" work? Yikes. How much is a gas turbine?

I got fed up with the cost of T boats when we were still using Nimh. It tied up too much of my boat resources. Then when something would go wrong it always cost hundreds of dollars. Oops, prop was too much baked a single cell in a matched pack. Ugh. Cold slolder joint. Another matched set wrecked. ugh. Or there goes another $600 speedo. Grab the extinguisher! Schulze will fix it in a few months. I'll have to buy a replacement canopy for the melted one. It just sucked. At least now there's enough information available to avoid the learning curve on 10s setups.

I think that's what Jim was eluding too. With an 1/8 scale on 10s there are plenty of guys that can give you guidance. Getting into this kind of setup is uncharted territory for 99.9% of the FE community. Nobody has done it. Well, nobody I've heard of. Anyone that tells you they have THE answer is guessing. Guessing with your money too. Even Jays math is an estimate based on years of experience. All that trial and error takes time and in some casses gobs of dough. Even if you call Steve Neu and have him design a custom system just for this boat....... HE's going to be guessing. That's a sharp dude but he's not a boat guy.

It's not a stupid idea. Crazy maybe but most of us are in FE land so you're in good company. It's the tie that binds us. haha Just make sure you know what you're getting into. Throw out any notion that finding the right setup will be reasonably priced and accept that there's a possibilty of total failure in the quest for speed. If you can accept those two things you'll be fine.

Oh.........and try not to kill anyone with it.

[jevmax]

If you are determined to power the hydro with electrics and have the money, consider using two Lehner 3080-8 motors, two Schulze 40-160 controllers, and 10S/10,000maH packs. Parallel drivelines. Start with Octura X465 props. Set up properly, that big hydro will fly and sound awesome. I'd love to see it go.

[Punisher 67]

Podagee nobody is saying its stupid but it will not be done on anything resembling a budget , I give you credit for wanting to do this - I have a 57" Apache and it is a huge pain in the a$$ carting this to the pond and back - my boat is pinner compared to what you want to build