Flexdrive cable adjustment

[shotimes95]

Ive soldered things like that before and using the hole drilled into either side will allow the solder to flow into the joint as long as the temp gets hot enough. In my opinion a pin may not be needed but theres alot of guys on here that know more than i do lol The engineer is coming out

[shotimes95]

65 shipped there on the swap shop but ppl want em for 40 bucks for the pair shipped and shipping is 15 alone! I really want to trade them for a x642 s/b and some $ but no one wants to deal... 65 isnt firm

[shotimes95]

im willing to deal and help someone out if they can do the same for me...

[Deserthobbies]

65 shipped there on the swap shop but ppl want em for 40 bucks for the pair shipped and shipping is 15 alone! I really want to trade them for a x642 s/b and some $ but no one wants to deal...

I may have an extra X642 prop, i balance my own , first one took me 6 hrs , then i bought a Stainless Steel and have about 8 hrs in it, its very time consuming to do it correctly sure glad i'm retired. lol

[shotimes95]

that helps! If he wants em give me a call. ill give u my number, i dont have paypal but will do whatever is needed to help a fellow rc modeler out! Ive been told a 642 will make a big difference. Im running a stock prop with darins tweeks and 2 7.4v lipos

[shotimes95]

wow ur a retired EE!! Im sure you could get a electric boat to scream! Im a body engineer for Ford

[Deserthobbies]

that helps! If he wants em give me a call. ill give u my number, i dont have paypal but will do whatever is needed to help a fellow rc modeler out! Ive been told a 642 will make a big difference. Im running a stock prop with darins tweeks and 2 7.4v lipos

I also ran Darins tweeks and they made a big difference , if you havent seen it i made my own tweeks but it does best with a 440/3 three bladed prop, im running Track Power 5000mah 40C lipos, got 42.6 mph today on the glassy smooth pond

[shotimes95]

40c is more than im running... i got 2 7.4v 4000mah 20c lipos. Just hope they make the boat run good!

[shotimes95]

One heck of a job on ur boat. Retirement really is paying off for you LOL Ive raced rc cars and trucks for the past 14 years and boats are new to me. But a forum and trial and error is paying off

[Deserthobbies]

40c is more than im running... i got 2 7.4v 4000mah 20c lipos. Just hope they make the boat run good!

the boat actually calls for over 25C batteries, watch your temps.

[shotimes95]

i didnt know that. proboat told me that the 20c were ok. they run losi 20c in there proboat video on horizon hobby. mine have a burst rate of 30c.. now u got me worried

[shotimes95]

and i have the timing on high and havent ran it yet

[Deserthobbies]

One heck of a job on ur boat. Retirement really is paying off for you LOL Ive raced rc cars and trucks for the past 14 years and boats are new to me. But a forum and trial and error is paying off

This is my first boat too, they are a blast , my Helis stress me out too much. I am considering putting floats on my Bell 47 for a boat recovery system. lol . yep too much time, ill sure be glad when Darins Stiletto gets here. i'm running out of stuff to do.

[shotimes95]

ill go pick up some 40c packs tomorrow...

[shotimes95]

would 5000 mah 50c be overkill?