29 V3 best stock prop

[dtacmed]

Any new recommended best prop for a stock 4s setup with the stock motor.

[Blevins]

X642 will do well on some good 2 cell lipos.

[fweasel]

I ran the x642 on 4s and ran 49mph all day long on the V3. It does run warm, so I would be sure to reroute your stock cooling lines: rudder>ESC>Motor lower barb>motor upper barb>hull outlet

[Fixitguy1]

I have a Miss Geico V3 29 and plan to run on 6s 5200mah 45c what prop would you recommend been thinking of a 440/3 just a guess
Any ideas

[fweasel]

I have a Miss Geico V3 29 and plan to run on 6s 5200mah 45c what prop would you recommend been thinking of a 440/3 just a guess
Any ideas

I ran a sharpened and balanced X440/3 prop on stock electronics with two 3S graphene packs and did 60mph consistently. The motor runs warm, so I rerouted the cooling lines to feed the motor first, then the ESC, opposite of my slower 6S setups. You also need to lower the stock ESC timing from 15* to 7.5* to use that prop, per Rafael at Proboat.

[Fixitguy1]

I noticed that the sponsons are pretty bad and plan to blueprint them, should I also include the flat part of the hull
Thanks for your input on cooling. Have a lot of work to do

[Erroneous]

You only need to blueprint the sponsons. The newer V3 hulls (with white epoxy inside) are near perfect though.

[Fixitguy1]

At first glance the boat looks good, then I had it on my desk in the sun and the deck had some waves in it and when I checked the sponsons they where just as bad.
It is the newer MG V3 hull. my friend has one also and have not checked it out yet, will tomorrow.
Thanks

[Erroneous]

https://m.youtube.com/watch?v=6SEhyXJnBYI