Miss Geico 29 ugprading ESC's

[lenny]

I would try that setup on 5s first and see what temps are,
And if all looks good,
Than try the 6s for 1 minute and check all temps.
Than if the setup is happy and warm try running for 2 minutes and so on.

Bump, can I run my s&b x642 on 6s with the 180A esc and 1590kv stock motor?. All connections are bullets


Sent from my iPhone using Tapatalk

[Ozzypatrol]

Ok, just about to put the ESC in the boat. What timing should I run it on for 4S, 5S and 6S on an X642 and proboat 1500kv V2 motor?

Cheers,

BJ

[iop65]

11.25°

[lenny]

Try it on 3.75 and check temps at 2 minutes, And the highest would be 7.50.
That is a stock PB 6 pole motor right ?

[Ozzypatrol]

Too easy, will need to run x642 for a bit, it's hard to get props in Australia

[Ozzypatrol]

Yeh mate, the v2 mg proboat 1500kv 6 pole.

[Ozzypatrol]

Boat ran well, got about 15 runs in on the weekend. Tried 5s with the X642. Didn't get a speed ut will post vids on youtube. Initially ran on 3.75 timing then pushed it up to 7.5. Temps all looked pretty good with the batteries coming in at the highest - 45degC. Also tried 6s with 3.75 had to pull the boat in after 1 lap as the strut set up just caused the boat to fishtail wildly without and extra speed.

[iop65]

like i said ;11.25° for that motor
3.75 that's for D-wind
this is a Y-wind!

[Ozzypatrol]

ah ok, will try again, was er'ing on the side of caution. Cheers mate

[Ozzypatrol]

is there a limit to how much timing you can add? Or do I just go off temperature?

[Ozzypatrol]

Sorry about the poor quality,

http://youtu.be/QJHaJDwqC7Y

http://youtu.be/xAsGpq6dEW8

http://youtu.be/om42CM-sn8g

[iop65]

is there a limit to how much timing you can add? Or do I just go off temperature?

max 15° here ,but check the temp with 11.25 first!