Proboat 1800kv motor maintenence

[mtbenjamin77]

Does anyone know if it is possible to change the in the proboat 1800? it is how do you get the can open

[kevinpratt823]

Does anyone know if it is possible to change the in the proboat 1800? it is how do you get the can open

change the what?

[JimClark]

Bearings?

[mtbenjamin77]

ya I sswear I typed the word bearing in there some where. the text editor on this site seems to cut and paste words when it wants to. funny. I wanted to change the bearings a motor I acquired through a trade but I managed to get the endbell off by heating with a micro torch and tapping on the shaft tilll it broke loose. After all that the rotor was shot

[Megabiker98]

Quick question sorry for thread jacking, but do u know if u r able to cut the motor wires? Or r they part of the motors windings?

[lenny]

Yes you can,
But hears some info before you do.
http://forums.offshoreelectrics.com/...igy-motor.Help
http://forums.offshoreelectrics.com/...otor-wires-cut

[ray schrauwen]

Sorry, I couldn't chime in earlier but, the AQ 1800 front end bell is threaded on (and rear too I think?). Were there any threads on the PB endbell? That would give reason to a possible smashed rotor??

I have a used AQ rotor if you want to go Frankenmotor.

ya I sswear I typed the word bearing in there some where. the text editor on this site seems to cut and paste words when it wants to. funny. I wanted to change the bearings a motor I acquired through a trade but I managed to get the endbell off by heating with a micro torch and tapping on the shaft tilll it broke loose. After all that the rotor was shot

[ray schrauwen]

Unless you want to send me the case and I Frankenmotor it out. Diameter is different I think?