revolt 30 leopard build..

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Cinnabun
    Senior Member
    • Jun 2013
    • 428

    #16
    Thats about where mine is, however when I first ran the red revolt with the leopard with the m445 it was way too aired out and blew over when I got close to 3/4 throttle.

    Comment

    • Cinnabun
      Senior Member
      • Jun 2013
      • 428

      #17
      Lol yeah man she was running very good until it snapped the prop shaft. I think the .187 cable is gonna take care of that though

      Comment

      • Cinnabun
        Senior Member
        • Jun 2013
        • 428

        #18
        Ran it again today.. didnt end well. The leopard is just way too powerful for this hull. With a neutral strut setting and 0* thrust angle, the bow is raising way too much and causing a blow over. It's about as fast as my stock revolt at 1/2 throttle, and if I try to pull full throttle the hull jumps out of the water and it goes crazy. Im going to raise the strut and drop the trim tabs a little bit and try again, also going to prop down. The m545 had way too much bite and threw the hull around like a rag doll.

        Comment

        • Cinnabun
          Senior Member
          • Jun 2013
          • 428

          #19
          Im going with a stock 42/55 grim and go up from there lol

          Also forgot to mention that I ran 2 heavy 8000mah 2 cells to the front of the battery tray

          Comment

          • Cinnabun
            Senior Member
            • Jun 2013
            • 428

            #20
            Its tons of fun. Lol.. today it flipped so bad it was in the air and blew to shore

            Comment

            • Cinnabun
              Senior Member
              • Jun 2013
              • 428

              #21
              Some slight nose damage, it should be repairable.

              Comment

              • Cinnabun
                Senior Member
                • Jun 2013
                • 428

                #22
                Yeh I dont think the revolt hull likes much over stock propped speed. I cannot get the hull to settle down

                Comment

                Working...