My NEW REVOLT 30.........w/Pictures

[JLShip]

DSCF2617.jpgDSCF2618.jpgDSCF2623.jpgDSCF2619.jpgDSCF2624.jpg

New Revolt......
5/32 Cooling lines, use 3/32 line as a collar(band) to make a tighter fit.
OSE Water Outlet and Bulkhead Fitting
OSE Carbon Fiber Battery Tray, you can change the hold down Velcro straps.
Reinforce Hull extra 1" wide med F/G under tray.
Pulled foam block from Bow, added pool noodle.
Prop X442 spare X445 (worked to be a M445) Both B/S by Chris Hoffmann(Dasboata)
Up-Grade OSE Flex cable 150x 3/16
Dinogy Batteries 4S 5000 65C

Will be running P-Limited Dist. 9 NAMBA (Hopefully I can still drive)

[skiking1739]

How in the world did you get the original battery tray out of your Revolt?

Thanks

SkiKing

[dirtnsnowrider]

[QUOTE=skiking1739;522829]How in the world did you get the original battery tray out of your Revolt?

Thanks

SkiKing[/QUOTE

Mine pulled right out as it was only held in with some white silicone.

[JLShip]

Skiking

It wasn't really bad, mine came out in pieces, Just take it slow...

[Phoebe]

Perhaps a dumb question, but why do you remove perfectly good foam only to stuff noodles into the hull? The factory foam is lighter and floats my boat just fine!?

[JLShip]

Perhaps a dumb question, but why do you remove perfectly good foam only to stuff noodles into the hull? The factory foam is lighter and floats my boat just fine!?

It's a personal preference, I've always used pool noodles when I started racing. Easy to remove and you can always get under the deck when needed, weight is not an issue..... When I first started 20 + years ago, used 2 part foam, hard to repair hulls when you can't get inside, went to the NOODLE after the 1ST wreak.

[skeeler]

How did you make the cut-outs in the battery tray for the straps? That looks like a good idea.

[JLShip]

How did you make the cut-outs in the battery tray for the straps? That looks like a good idea.

With a Dremel, Mark how much you want to cut out with marker, you don't need much, clean up with file,Just watch out for the dust, wear a mask if you have one. Placement, raise it about little over 1/8", cut some ply on a 33* 1/4 wide strips enough to go under F/C Battery tray and Hull, Used resin and some cloth on the under side of tray, then used resin on sides, none at each opening, were Velcor Strap go.

[skeeler]

Thanks. I'll emulate your idea.