ABC high pitch props

[MG1234]

A 2014,I'll look that up on my chart ,you have to sharpen and ballance yes?

[zooma]

Travis, are these ABC cleaver props detongued to approximately the same as Octura M props?

[MG1234]

And do they need to be finished? Or are they ready to go? They look like they need finishing,

[dmitry100]

of course they need sharpening and balancing ... talk to dasboata about that.

[MG1234]

So that's a 2" prop ,do any ABC come finished? What boat are you putting that monster on ?

[kfxguy]

All abc props need finishing. The new ones are very closely balanced out the bad tho. I ran a couple raw for the heck of it and results were poor. They need sharpening and balancing.


The big prop is slated for my shocker build. Maybe even try it on my kbb34 on lower voltage.

[Turbo Dan-O]

...

[dmitry100]

What are you gonna run that 2014 abc on, kfxguy?

[Jamey]

Travis, are these ABC cleaver props detongued to approximately the same as Octura M props?

Sorry not Travis but I can tell you they are detongued MORE than Octura M. That is why they have less bite at slower speeds but are very efficient at high speeds.

[Jamey]

All abc props need finishing. The new ones are very closely balanced out the bad tho. I ran a couple raw for the heck of it and results were poor. They need sharpening and balancing.


The big prop is slated for my shocker build. Maybe even try it on my kbb34 on lower voltage.

I was thinking of trying the 2014 on my pursuit, especially when running 5S. Let us know how it does if you try on your kbb34. Thinking it will be very close to a 1915 speed wise.

[zooma]

Sorry not Travis but I can tell you they are detongued MORE than Octura M. That is why they have less bite at slower speeds but are very efficient at high speeds.

Sounds good.

[MG1234]

Wow I'm the only guy in 100 miles with a RC boat,that's why I need so much advice ,:)

[rayzerdesigns]

All abc props need finishing. The new ones are very closely balanced out the bad tho. I ran a couple raw for the heck of it and results were poor. They need sharpening and balancing.


The big prop is slated for my shocker build. Maybe even try it on my kbb34 on lower voltage.

the new ones I got were way out of balance

[kfxguy]

the new ones I got were way out of balance

Make sure the hole drilled through it is centered. There was a bad batch here recently because tooling got messed up. It's straightened out now.

[Turbo Dan-O]

Just got in this 1715-17. It's waaaay heavy on one side but the hole looks centered. Well, here it is(bare) next to an M445(shiny). Hard to tell from the pic but this thing is crazy looking!