I have a Vac-U-Pickle that is currently running:
- 2200kv GForce
- 4s 4400mah 65-130C NanoTech
- Turnigy Marine 120A
- 42mm 1.4 Pitch 2 blade CNC prop
From my build thread:
"I'm looking to get a little extra out of this setup by switching the prop. Right now, I am running a 42mm 1.4 pitch cnc prop from Kintec. My motor and ESC run cool. The batteries are a little warm, but not alarming in any way. I was thinking about dropping back down to a 40mm prop, but with 1.8 pitch. That would take it from 58.8mm per revolution to 72mm. The one below is advertised as a no lift prop. Any advice?"
Here is the prop I was thinking about.
http://www.ebay.com/itm/171117224918
Current Setup
- 2200kv GForce
- 4s 4400mah 65-130C NanoTech
- Turnigy Marine 120A
- 42mm 1.4 Pitch 2 blade CNC prop
From my build thread:
"I'm looking to get a little extra out of this setup by switching the prop. Right now, I am running a 42mm 1.4 pitch cnc prop from Kintec. My motor and ESC run cool. The batteries are a little warm, but not alarming in any way. I was thinking about dropping back down to a 40mm prop, but with 1.8 pitch. That would take it from 58.8mm per revolution to 72mm. The one below is advertised as a no lift prop. Any advice?"
Here is the prop I was thinking about.
http://www.ebay.com/itm/171117224918
Current Setup