cowling hardware

[JimClark]

Anyone found anything recently to hold cowlings on? Trying to get ideas for the back of the cowl on my Micro Hydro. The front is no problem just the back.

Jim

[domwilson]

Will the SV27 lock work? http://www.kintecracing.com/Supervee_27_upgrades.html

[JimClark]

Nope I have to have two of what ever I use one at each back corner.

Jim

[bustitup]

Anyone found anything recently to hold cowlings on? Trying to get ideas for the back of the cowl on my Micro Hydro. The front is no problem just the back.

Jim

http://cgi.ebay.com/aluminum-hatch-c...4.c0.m14.l1262

and another one

http://cgi.ebay.com/Heavy-duty-alumi...4.c0.m14.l1262

[domwilson]

http://cgi.ebay.com/aluminum-hatch-c...4.c0.m14.l1262

and another one

http://cgi.ebay.com/Heavy-duty-alumi...4.c0.m14.l1262

I thought of suggesting these. I have a couple. But I think they would be too large for a small boat.

[G Doggett]

I use small countersunk stainless screws set flush with the hatch in the corners.
The screws go into a triangular piece of 1/8 plywood in each corner of the hatch opening.
The hatch is still sealed with tape, but the screws make sure the hatch wont blow off in a big wipe out.
I can provide a picture if you want.
Graham.

[ozzie-crawl]

i would like to see pics

[video200]

personally i like this ones http://206.206.85.209/xtdoc/Details....1&store=mhzusa
not shure if you can use them though

[ozzie-crawl]

i need some thing as well for my sprint cat, would like to try the ones on this boat (hopfully txboatpilot wont mind me using his boat pic) they dont get in the way of taping or leak,just dont know were to buy them

[properchopper]

Two methods I use : [ for front of hatch, should work on back also]

#1 ; rivet mating with hole on Drifter S

#2 ; garage door opener clip on DF 33 - maybe too big for small boat

[G Doggett]

This the screw down system that is on my Jolly Cat which I have copied on my other boats.
graham.

[teach]

I really been thinking about some of the small rare earth magnets. I have a few and good lord the are damn near impossible to seperate them from each other.

I have seen a few sellers that make thin square and circular ones (thin enough to tape over). I'm just a little worried they may be to strong and end up tearing the fiberglass.

[tylerm]

i need some thing as well for my sprint cat, would like to try the ones on this boat (hopfully txboatpilot wont mind me using his boat pic) they dont get in the way of taping or leak,just dont know were to buy them

Pretty much any good online gas rc boat store has them. However you can make them yourself with bits and pieces from you LHS(or HK if your that way inclined) and some o-rings from a local seal specialist/supplier.

http://mastonsrcmarine.com/Page412.html

Tyler.

[tylerm]

This the screw down system that is on my Jolly Cat which I have copied on my other boats.
graham.

Graham what are the locks you use on longlite and miss zenoah called? i was just wondering if a smaller version of these would work for jim (op).

[ozzie-crawl]

thanks for that tyler,know i have seen what they look like up close i can make a set