How to hook up motor in Syncron

[paulwilliams]

I always thought that Toysport uses normal cables , like 4,75mm

I made some replacement flexis for the stinger on a friend's Syncron. The cable was 0.150" into a 3/16" shaft.

Paul

[Steven Vaccaro]

Most all the shafts I've seen on his rtr boats are 5mm with a 3/16" end and 150 cable

[paulwilliams]

Most all the shafts I've seen on his rtr boats are 5mm with a 3/16" end and 150 cable

Hmm - maybe they were 5mm -> 3/16" - I'd have to check.

Paul

[H2OCamel]

Well my caliper says the cable is 0.147 inches?

[paulwilliams]

Well my caliper says the cable is 0.147 inches?

0.003" is within the cable tolerance - 0.150" is only a "nominal" size.

Paul

[H2OCamel]

Steven,
any tips to help setup my syncron? cg? photos of interior layout?

[Jeff Wohlt]

5 mmx 150 then.

[H2OCamel]

Yes!
And the cap came off in seconds with the torch it must have been loctite.

[Steven Vaccaro]

Steven,
any tips to help setup my syncron? cg? photos of interior layout?

Does yours have a flood chamber? What cells are you running with the 8xl?

[H2OCamel]

I have been running 4s (2packs of 2s in series) with a x637 prop on a similar sized mono and i'm swapping that combo to the syncron. Yes it has the flood chanel in it.