JAE 33 Rigger 6s Oval Set up.

[ray schrauwen]

thanks for the reply's I'm going to start with a TP 4060 1350kv "Y".

This motor is much nicer @ 1350kv.... MUCH nicer...

https://www.offshoreelectrics.com/pr...d=ten-evo-2260

Great Deal!!

[RaceMechaniX]

Nice rigger! Where can we get one?

Brian Buass builds the Raptor's. There are only two of these built to my knowledge. I have one and Mike Ball has the other. You can reach out to him here, his handle is raptor347.

[M3Bluegsr]

bad choice on every level. D winds are less desirable because you have no timing control. look for wye wind. 1700kv sucks for both 4s and 6s lapping. that would be ok for speed run on 6s but not lapping. 1200-1500kv = 6s lapping motor. the 33fe barely floats with a P-limited setup. 6s they sink. lots of people have lost theirs. they dont have enough room for flotation. a 4050 is already pushing it for 6s pretty severely. 4060 is kind of the bare minimum.

zippkits is releasing a 6s rigger its been in development for well over a year. run 4s in a 4s rigger, run 6s in a 6s rigger. The 33fe should be able to lap over 60mph in 4s and do 2-lap time trial over 70mph on 4s with a castle ESC.

This isn?t true information.. I ran 1700kv TP on 6s in my sport 40 and won the series championship in my district. Also raced my 33FE for several years on 6s without it sinking. The 33FE in its time was too big for P-limited, was more suited for full P.

[jingalls007]

Brian Buass builds the Raptor's. There are only two of these built to my knowledge. I have one and Mike Ball has the other. You can reach out to him here, his handle is raptor347.

Just saw this reply. Thank you Tyler. I thought maybe it was a kit for the general public.

[ray schrauwen]

I have a cad drawing of a 45 G rigor from zip kits all it is is template profiles. Is that of any interest?