TP-Power 4050 3Y 2220kv

[twissted]

tp-4030-800x600.jpgI'm waiting to get these from TP usa. I looked here first but they only had one. I'm going to put them in my modified Zonda cat.
I would like to know is any one is using thes motors in a cat and what props size your using? The Zonda is a 42 inch hull I use 6s and 1640/2 cnc props that are stock and I also have the 1445/2 cnc props. The hull has been beefed up to use larger props.

[bracka69]

There is a build thread on here way forum member ManuelW did a HPRC5009 45" hull build using the TP4050 2350kv motors and was using a pair of Octura X447's and also some 50mm props cut down a bit on 6s with the same 180a turnigy/seakings like in your photo and they achieved speeds over 100mph.

[twissted]

That is a fast boat! And is what I was looking for thanks!

[bracka69]

That is a fast boat! And is what I was looking for thanks!

No problem man. Glad I could help. I have a HPR C5009 being built for me now with the 2nd generation 4050's 2390kv.

[twissted]

Should be a fast boat!

[twissted]

X945-R and the X945 cnc props from kintec are on the way also.

[bracka69]

Should be a fast boat!

Hoping to get in the triple digits.

[twissted]

It should get there!