Setup question

[lenny]

That is the leopard 4074 1800kv and 180a Turnigy esc Tim.

If you are going by yourself and want to get video's,
I do this with my camcorder, And use velcro straps to hold it to the tx.
Than I aim it like a side arm gun and just try to stay in frame with the boat.
It get easier the more try it like that, But I just can not zoom in and drive at the same time yet,
But you are having enough troubles just trying to drive at the moment.

camcorder 004.jpgcamcorder 003.jpgcamcorder 002.jpgcamcorder 001.jpg

[Rooky]

Lol

[tlandauer]

Lol

He has seen my handi work!

[lenny]

And Tim would have his boat dry docked on the beach some where,
With Tim trying to swim a shore and keep the camcorder dry.
But it all good fun when you look back at it.

[tlandauer]

And Tim would have his boat dry docked on the beach some where,
With Tim trying to swim a shore and keep the camcorder dry.
But it all good fun when you look back at it.

Hey, at least my new camcorder is water proof to 16.4 ft for 1 hr.

[lenny]

Good you will need it,
All right get some video's now of that fleet of yours.

[tlandauer]

Good you will need it,
All right get some video's now of that fleet of yours.:popcorn2:

Too many mods and up grades, I have to true a hull tomorrow, one day I will take a still photo of my fleet. Notice I say STILL?!
Anyway, I lost my summer because I had to work overseas.

[Savage Skidoo]

Hey Chris now you cant blame my prop

I see some tips i gave you ....worked , now you need to control the force Luke

[Rooky]

Hopefully tonight will yield better results :)

[Rooky]

52.8mph tonight and it stayed right side up!

[Heaving Earth]

52.8mph tonight and it stayed right side up!

Good work

[Rooky]

Now the caps on the esc were 130f and the motor was 160f.
It is running a t600 1100kv outrunner @15* timing with an x450 prop. I lowered the strut from where it was lastnight. Any more hints? Are my temps too high?

[lenny]

Get some good video's of it running,
Also how long did you run the boat to get those temps ?
The temps are pretty good on the motor and caps.
How about the connectors and esc board and flex tube temps and cells ?