Cutting carbon for transom

[shctexas]

I just use reg craft sissors, check out my post , MADD Catt I addressed cutting clean edges there, I'm on phone right now so it's hard to type

I had the same dilemma but stumbled across a post here that suggested using spray adhesive to tack fiberglass cloth to the back of the carbon fiber. i tried it works great. I used a light fiberglass.

[Cooper]

Yes in certain situations this works great. I think I used 1/2 oz Fiberglas. A very light "mist" of the spray adhesive is all that is needed.