Bearing for a Leapord 4074 2200kv.

[tagasagwan]

Tagasagwan

here ya go

http://www.bocabearings.com/bearing-...otors-t600-all

I used the BMK-005 part number. it comes with 3 bearings. 1 large and 2 small ones.

Thanks Carl! This is very helpful!

[lenny]

Thanks for your input and honesty Ray.

But this is what he posted and also told me with pm's.
http://forums.offshoreelectrics.com/...arts-and-lipos
So buyers beware this could happen to you to,
I was very lucky I listened to the motor.
This could have burned,
The esc and cells and boat up if I ran the motors the way they seller sold them to me.

I'm sorry, I was going to bite my tongue but, I can't.

I would never sell a motor like that 1900kv motor and call it almost new. I know Lenny, you said it is almost new but, did the guy selling it to you call it that? At best it is used very hard.

Carbon wrapped cores when heated too much will snap fibers since CF shrinks under heat. Kevlar wrapped cores expand with heat.

Since the carbon is that freyed, it was overheated/overloaded in order to get enough shrink to snap a CF wrap.

I would never ever sell a motor as "almost new" in this condition. IMO both motors are junk, fixable but, very limited life left.

You can use thin or Med CA but, a slow set epoxy or CA will hold better in the long run.

Sorry man, just my opinion, I know everyone has one... like other things...