just curious what the recommended timing is on a 1860kv 1521 neu with a t180 esc,I will be running it in a 31 inch mono on 4s2p and a x447/2 prop?
first neu motor for me....
first neu motor for me....
-
-
Timing - 3.75
Should be able to run a detounged 447/3 with that set up especially since its running 2p.
Trev -
3.75 works fine. Bolt on a 450/3 and hang on
(motor won't break a sweat, watch the T-180 temps)
2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
'11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /MonoComment
-
driftah
go with a 445 first run it for a minute then check temps
then go with a 447 and do the same thing
then IF EVERYTHING checks out, THEN try a 450.Comment
-
My Titan 40 with that motor and 4S2P pulls over 200 amps continuous with that x450 prop, be careful! It is awfully fast though....
.ERROR 403 - This is not the page you are looking for
Comment
-
weird the orig owner told me closer to ten deg. hmmmmmComment
-
It's a d wind. 3.75Comment
-
then again, I use 0 timing and a detongued 452... dang that's fast.. and warm when she gets in, but then are you racing to keep you equipment cold or to win?"Look good doin' it"
See the fleetComment
-
I sent an e-mail to Steve Neu about four years ago asking about timing, and here is what he said:
D winds : 0 - 4.75
Y winds : 9.0 to a max of 15.0
.
ERROR 403 - This is not the page you are looking for
Comment
-
sounds good but old owner is saying ten yikes,I will go with the 0 to 5 area lolComment
-
i run this motor in a 34" mono 4s2p t-180 and run a 450 3 blade no problemSocal Fe member, miss gieco castle 1515 1y t-180, blackjack29 stock,insane FE30 p sport castle 1515 1y t-180, insane FE30 p spec ul-1 motor t-120, insane 34"mono neu 1521 1.5d t-180Comment
Comment