Newbie in the neighborhood !! Can someone tell me what I have here

[dereckg]

there is only one way to learn Trial and error ! Im pretty good with direction I have the balancer it came with directions So after I put the connecter on the fountain I will start on the prop ! then i have another project to start !! Im going to turn a nikko cruiser in2 a recovery boat for distant on water failure

[Make-a-Wake]

That is not original MRP equipment hanging off the back LOL.

Here's what it looks like stock.................before I modded it to a stinger drive:

[Heaving Earth]

there is only one way to learn Trial and error ! Im pretty good with direction I have the balancer it came with directions So after I put the connecter on the fountain I will start on the prop ! then i have another project to start !! Im going to turn a nikko cruiser in2 a recovery boat for distant on water failure

yeah i guess we all learn somehow. this wasnt the prop i started on, but it took me a solid 4 hours to do nicely.

[dereckg]

nothin but time here Usually in my shop 4 to 6 hours a nite anyway !! Got everything I need to survive !! fridge with cold drinks and food tv bathroom radio could stay there for a couple days without goig out My fall out shelter

[dana]

lol i need a fridge in my shop, theres just no room… too many rc's and guitars... mehehe

[dereckg]

I had to build a shelf over fridge to accomidate rc's And the tv hangs from the ceiling as to not take up any shelf space !

[Make-a-Wake]

I mistook this for an MRP Fountain boat thread......................

[dereckg]

Its what i would call carrying a newbe thread !! LOL Ok the next problem is !! Is there a trick to installing the water jacket on the motor !! My prop is done so I put it on the boat ! As I go thru and check everything to get it ready for 2moro I notice the end cap is loose so curious me has to take it all apart Now i attempt to put the jacket back on and the orings wont stay in place !! Ive tried lubein it every trick i could think of just short of glueing it in place !! Any words for me !!

[dana]

Its what i would call carrying a newbe thread !! LOL Ok the next problem is !! Is there a trick to installing the water jacket on the motor !! My prop is done so I put it on the boat ! As I go thru and check everything to get it ready for 2moro I notice the end cap is loose so curious me has to take it all apart Now i attempt to put the jacket back on and the orings wont stay in place !! Ive tried lubein it every trick i could think of just short of glueing it in place !! Any words for me !!

what motor?

[dana]

stocker what? are we talking ul1 here? your thread is about an mrp

[dereckg]

stock UL 1 motor its yellow dont know to much about marine motors yet

[dereckg]

told you this is the carry the new guy thread

[dana]

those are tricky to get back on. why on earth did you remove it? you just have to tinker to get it back on. maybe someone has figured a trick to it will chime in

[dereckg]

LOL I have the curious thing goin on rite now !! Like one of those need to know whats inside things!! Probly why I had so many kids... But, the good thing is only two left with a min. of seven years till the last one turns 18 !! 1 just turned 18 this year and on his 2nd move out

[dana]

good luck with it. if youve done your prop correctly, you should see 50mph.