LED lighting mods

[Diegoboy]

Here's my FE LED project. What's in the picture is a JAE12 sponson with 8 LED's in the sponson overhang and one in the sponson transom. The tub has 2 white LED's in the nose and 4 red LED's in the transom. The tub was also widened

[sundog]

Quick question, how are you plugging the LEDs in? Are you using a 3rd channel on your receiver?

I have a 2 channel receiver and was hoping to use the BAT slot, but don't think it will work.

You can use an HPI reverse mixer and a receiver switch to operate many lights. When you hold your throttle forward (reverse) for three seconds, it sends a signal to a servo - or receiver switch that can handle up to 30v and 10A - that's a lot of lights! Then just hold the throttle forward again to turn them off. Easy, electronic method for a two channel Tx. I have an HPI mixer available in the Items For Sale section.

[domwilson]

Danny,
What did you use to trigger the LED's? To make them flash in sequence like that?

[Diegoboy]

I used a logic board!

[domwilson]

Did you build it or purchase it?

[Diegoboy]

I had a guy build it for me.