Corrosion-X Heavy Duty

[properchopper]

Just got some of this to test. Non-hardening, kind of oily-greasy, but insoluble in water, non-conductive and boils at 475 F. Will test on speed controls- figure it'll coat better than regular Corrosion-X. More to come after testing.

[JimClark]

thicker also?

[Diegoboy]

Interesting!

[properchopper]

thicker also?

Yup, should provide a thicker layer of protection.

[Jeepers]

I was told by one of our northern club members NOT to use it on circuit boards it warps/melts them he said he found out the hard way when he sprayed on his RX in his nitro boat. just what I was told, I never bought or tested it.

[Big Bopper]

I have used the HD on a receiver and it did not work there .I also haved used it on servos and it worked great there .

[properchopper]

I was told by one of our northern club members NOT to use it on circuit boards it warps/melts them he said he found out the hard way when he sprayed on his RX in his nitro boat. just what I was told, I never bought or tested it.

I've been using the regular, Red can stuff for years without any problems. I'll test this stuff out on a fubar'd speedy circuit board - (got plenty of them). Thanks for the heads-up !

[Big Bopper]

I was told by one of our northern club members NOT to use it on circuit boards it warps/melts them he said he found out the hard way when he sprayed on his RX in his nitro boat. just what I was told, I never bought or tested it.

Yes that is what happend warp my RX circut bord but that was the first run of the HD but Kelly did tell me that they have it changed it and will not do this any more .But i have not tryed this my self again .

[Jeepers]

I have been using the red can stuff too no problems.

[Jeepers]

Yes that is what happend warp my RX circuit board.

LOL!!! it WAS you that told me that!! I couldn't remember for sure.

I wouldn't try it again either.

[properchopper]

Yes that is what happend warp my RX circut bord but that was the first run of the HD but Kelly did tell me that they have it changed and will not do this any more .But i have not tryed this my self again .

I spoke with Nancy at Pacific Corrosion Products (very nice person) and told her what I intended to use it for & wasn't cautioned about any potential problems. I will test on a board tonight & see what happens.

[Jeepers]

let us know properchopper!

[Big Bopper]

LOL!!! it WAS you that told me that!! I couldn't remember for sure.

I wouldn't try it again either.

Yep it was me .I did talked to Kelly Stout (Corrosion X dealer)and he said it will not do this any more

[forescott]

How do you apply corrosion-x to a speed control? I've never done it before. Just remove the shrink tubing and spray the entire enchilada? Do you remove the cooling plate first??

[properchopper]

How do you apply corrosion-x to a speed control? I've never done it before. Just remove the shrink tubing and spray the entire enchilada? Do you remove the cooling plate first??

I just stick the straw in one end & let 'er rip.