9xl on 6s in df29????

[driftah]

anyone ever done this or is it a grenade setup...I will be using a small prop as well maybe a 42mm etc.?? this isnt for racing just for saw type runs in a large pond ..just want a bullet lol

[RIPFENCE]

when i fist started i tried a 10xl on 6s in a df29 is and it grenaded..the boat was very fast for a very short time...do not do it

[Simon170]

How do you mean mate? What happened to it?

[785boats]

I think you need a smaller prop than that.
Don't forget that a fully charged 6s pack is 25V. Thats around 46,000 rpm.
A 42mm prop will smoke something, I'm pretty sure.

Paul.

[blackcat26]

A x438 would be a safer bet. I have ran my miss geico on 6s, 1800kv motor, x438 and m440. I was using a 150a esc and everything was good.

[RIPFENCE]

How do you mean mate? What happened to it?

lets just say ther were some pieces inside that were not supposed to be in pieces lol

[blackcat26]

This was a castle motor. Feigao may spin apart....ha

[driftah]

ok not gonna try it then hehehehe dont want pieces in my hull lol even with a 38mm prop

[RIPFENCE]

anyone ever done this or is it a grenade setup...I will be using a small prop as well maybe a 42mm etc.?? this isnt for racing just for saw type runs in a large pond ..just want a bullet lol

get one of the cheap castle 1515's 2200kv and try 5s..that will give you a bullet for sure with a tougher motor then the feigao..that df29 will take offf like a kite though

[RIPFENCE]

ok not gonna try it then hehehehe dont want pieces in my hull lol even with a 38mm prop

the magnet was in pieces and the shaft was seized up..which blew my controller too

[driftah]

I threw a 2200kv castle in it but never had the balls to use 5s on it hehe,I run 4s w x445 prop and it is ok but I love speed

[RIPFENCE]

I threw a 2200kv castle in it but never had the balls to use 5s on it hehe,I run 4s w x445 prop and it is ok but I love speed

hahaah well i guess its time to "ball" up now isnt it?? lol that is if you want to try a saw setup..still real high rpm's 40,000 unloaded..i would prop down though too..maybe some of the saw guys will chime in and give some real advice

[Alexgar]

5s and 6s on a cc 2200 just for kick , wicked fast but no long term results to talk of it probably kills the motor but the rebuild kit is $25

[lomdel]

9XL on 6S will ! Try to calculate rev speeds of 29k to max 35k. I run a 12XL off 6S in my TC31 and it goes plenty fast, but I will try a 11XL in the near future as well...

[T.S.Davis]

That's not enough boat for 6s IMO.