Twin Outrunners on a Hydro?

**Dangerous_Toys** · 11-14-2010, 09:48 AM

Originally posted by Fluid View Post

Use 1/4" cable, absolutely. You will eventually break a 3/16", but the 1/4" will be pretty much bullet proof.

.

Should the 1/4" cable be stepped down to a 3/16 shaft to accommodate 3/16 props or should that stay at 1/4 shaft also to run the larger 1/4 props?

**Dangerous_Toys** · 11-15-2010, 04:00 PM

So, should I go with a 1/4 shaft as well as a 1/4 cable? Anyone?

**don ferrette** · 11-15-2010, 04:45 PM

Originally posted by Dangerous_Toys View Post

So, should I go with a 1/4 shaft as well as a 1/4 cable? Anyone?

1/4" cable with step shaft to 3/16" should be fine, will give you a greater selection of props. Most 1/4" bore props are a bit much for FE.

Comment