Whats a good Fe tunnel hull ???

[Brushless01]

So whats a good one ??

[Kris Flynn]

What Size?

IMHO The Vision 20 is a great boat for P-Spec (even P) it is 29.25" long
Other goods ones are the VS1, Cobra

Kris

[Deserthobbies]

Check out the new proboat stiletto, supposed to be out in about 3 weeks.

[Doug Smock]

I would second that on the ProBoat...I have a VS-1 set up as an FE and it's great as long as there are no boat wakes, but it tends to trip and spin out a lot...

You may need to work on your set up.
There are three at the club that are rippin and snortin with UL-1 motors, and modded 4255s.

[boogaloo_d]

I run a Hydro&Marine F-1 Skater with a UL-1 motor and ESC, and it good boat. It's easy to drive and very stable. Its fast too.

Doug we had a great time running with you guys in Atlanta. Cant wait to see yall at the SOEGA race.

Jimmy Duncan

[Brushless01]

Is the graupner tunnel any good ??

[Doug Smock]

I run a Hydro&Marine F-1 Skater with a UL-1 motor and ESC, and it good boat. It's easy to drive and very stable. Its fast too.

Doug we had a great time running with you guys in Atlanta. Cant wait to see yall at the SOEGA race.

Jimmy Duncan

It was great to have you guys Jimmy!!
We could have done without the two flash floods, but other than we had a blast!!

See ya in Sycamore,
D.

[longballlumber]

I am currently running a VS-1, OS leg, modified grim 42X55, UL-1 power (speedo and motor) and it will run with the best of them. Mine runs 42-45 mph all day long. It's super stable and a ton of fun to drive.

I would also take a look at the TS3 that will be released soon by AquaCraft. I raced the Prototype version at last years nationals with the same set up as above, only I was running a modified M445. It's a little longer than the VS-1 so should handle rougher water (as long as it's properly set up). I will be looking at getting one this fall for a winter build.

Later,
Mike

[Brushless01]

Will there be a fe ts3 ???

[Doug Smock]

I'll take any and all suggestions as far as drive depth and angle. COG is at 8-inches and the VS-1 flys at an angle of between 2 and 5 degrees...problem comes with wakes where it spins out and "trips" usually flipping over. It came with stumble pads installed.

If you'd like send me your email address in a pm.
I have Trini's VS 1 in the basement and she's a runner.
I'll send you some pics, maybe you'll see something that will help you out.

Doug

[longballlumber]

Will there be a fe ts3 ???

Like most tunnel's you will need to convert for FE use. If I can do it, anyone can!!!

Later,
Mike

[longballlumber]

I'll take any and all suggestions as far as drive depth and angle. COG is at 8-inches and the VS-1 flys at an angle of between 2 and 5 degrees...problem comes with wakes where it spins out and "trips" usually flipping over. It came with stumble pads installed.

Which lower unit are you using?

Later
Mike

[Brushless55]

I think the TS3 looks sweet

[eboat]

Vision 20 is better
I had a TS2 but the vision 20 is way more stable

All white boat is the vision 20 the coloured one is the TS2

[adamb]

Anyone run the bby tunnel?