How to determine what electirc motor goes into this 36" mono?

[Chenige]

Have this older 36" mono hull that had a Picco .46 in it. Where can I go to determine what electric motor size is good for it? I asked Copilot but hope you all have better ideas!

Any idea what boat this is?

thanks,
Chris

[koen]

it looks like a seaducer ,for a motor 4092 and depending how fast you want 1250 to 1650 kv on 6 to 8s and for esc 200amp and up

[Chenige]

it looks like a seaducer ,for a motor 4092 and depending how fast you want 1250 to 1650 kv on 6 to 8s and for esc 200amp and up

Thanks! I do now remember it was a Seaducer.

In looking at photos of Monos I see the motors are more to the rear of the boat than where they put the Nitro motors. Is this for valance reasons or minimizing shaft length or ? Can I put the electric motor in the forward position so I can leave the rest of the hardware?

Where is a good place to go to learn set up of electric boats?

[koen]

you can use the same place of the nitro motor but keep the CG the same ,you can move the batt's more forward or to the rear depending the wind and chop
and a good place to find a good setup is just this forum