La saws???

[RandyatBBY]

Darin,
Very sorry to hear about your dad.

Bill,
Welcome to the 80mph club!!!

Randy,
Way to go on the records!!! How did your P-hydro do?

Chris

I really did not run it much, it belongs to Paddy and I just did a little testing to check how it works. I need to build one for me that is 34 inches long to fit in the rules. Then I can thrash the living crap out of it.

[RandyatBBY]

Darin, it has a lot of potential, I had issues with hardware, my bearings kept falling apart, and once I had that issue worked out, I found out that I had too little AOA on the sponsons and the hull would run very wet... to be honest I was kinda expecting some sorta problem, I had to put her together in 4 days and went to the event untested...

It's a pretty well built hull, better then I was expecting, the hatch fits perfectly, sharp edges, a couple of pin holes in the gel here and there but other then that, just a nice little hull. The sponsons are wicked, they are well made and light, perfect for oval races or a loose SAW hull. Thanks for asking.

The CF work is real pretty I must say. But you better know how to set up a rigger or you are in trouble. There is no drilled holes to go by for the sponsons.

[RandyatBBY]

Rigger shots

Rumor has it that Randy will be selling this boat as a kit, the Oxidean pro model

You know how it is all the SAW boats are custom order. The person must call and order the boat on the phone. Thanks Will you made me look good. I sure had fun!

[Ub Hauled]

The CF work is real pretty I must say. But you better know how to set up a rigger or you are in trouble. There is no drilled holes to go by for the sponsons.

Randy, thanks!
A little correction, there were little original holes on the sponsons, I had to change the location of because I wanted them placed in a different spot and angle (turned out to be too little) and pushed forward a bit... there are guides though.