Motor wires cut

[bigwaveohs]

Ugh! You need to have the right length of the factory spec. I think you know that hence why you are asking. The way brushless motors work is that if they have bullets on them like a Tenshock, you can have any length wire on it. When a brushless motor has the lines go into the motor they have to be the right length as the length is used as a resistance for the signal line. Hopefully someone has the same motor and give you the exact correct length and or if Leopard can provide the info. Good luck!

This makes no sense since different ESC's have different length motor wires, and depending on which one you use, the overall length will be different. And what about those who need to lengthen the ESC wires on their tunnel hulls to reach the OB motor?
Randy - I think the real problem is how to solder to the existing wires without damaging the internal wires and insulation...better send it to the factory and have them re-attach new wires to the motor windings.
JMHO