All you FE experts have any thoughts on leopard 4074 2000kv on 6s?

[jimbo--jones]

Will 4 of these work? It says 2s2p. If I put two in series I get 4 cells yes?

http://www.hobbyking.com/hobbyking/s...dProduct=14697

[jimbo--jones]

Will 4 of these work? It says 2s2p. If I put two in series I get 4 cells yes?

http://www.hobbyking.com/hobbyking/s...dProduct=14697

[Make-a-Wake]

Yep, and those are some stout batts..........200a constant discharge!

[jimbo--jones]

so it wont matter if is 2s1p or 2s2p? Im grabbing 4 of them then. Cheers guys

[Make-a-Wake]

Check the measurements before you order.

[Rumdog]

Why do you need 10,000 mah?
Why not just sell the motor and go for a lower kv.
You will destoy that motor, when that goes, so can the esc, so can the rx, so can the servo, so can the lipos, not to mention what the hull will look and smell like.
At that much rpm, when the boat/prop hops out of the water and unloads, then re-enters you're going to se MASSIVE amp spikes.
The motor won't run efficiently in that configuration either. It will heat up, and lose power. That is if it doesn't de-mag first.
What boat is this?

[Make-a-Wake]

He'll have 5000 mah to each esc/motor........................

[Rumdog]

oops. missed that part

[jimbo--jones]

it was running 2 motors, so only 5000mah each. Thats what happened on my last boat rumdog, so thought id check 1st this time.

[jimbo--jones]

although if i get these 2 cell ones it would be 10000mah each motor ay? Means mega long run times yeh?

[jimbo--jones]

or is that ony when you put them in parallell?

[Make-a-Wake]

Parallel will give you 2s power and 10,000 mah...............series like you're wanting will give you 4s power and 5000 mah.