New Turnigy Outrunners

[crabstick]

http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=11102

Just ordered this 1100KV bad boy for my 36inch sprintcat, flagging twins and going for one of these on 6s for the meanwhile.

http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=11143&Product_Name=Turnigy_T600_Brushless_Outrunner_for_600_Heli_%28880kv%29

880kv also

[Fluid]

"We wont tell you anymore..."

Like no max wattage, then they recommend a 100A controller for a 110 amp motor, etc. The price seems too good - about 1/3rd that of a comparable Scorpion - hope it works out for you.


.

[Mel279]

Let me know if u can spin it like the scorpion motor

[vasy]

I was thinking of getting one, but shaft is 6mm, where do you get 6mm flex cable to motor connector, they all seem to be 5mm?

[crabstick]

I was thinking of getting one, but shaft is 6mm, where do you get 6mm flex cable to motor connector, they all seem to be 5mm?

From my lathe

for $61nzd shipped here I cant really go wrong, Plus its not for club racing as there is not currently a class for the boat its going into.

[vasy]

From my lathe

bummer.....

[crabstick]

pretty sure OSE sold some 6mm couplers for the KB45's when they sold them.

If not try Jeff Wohlt on OSE

EDIT : Behold - http://www.offshoreelectrics.com/pro...oct-ocfhe6mm18

[Mel279]

I was thinking of getting one, but shaft is 6mm, where do you get 6mm flex cable to motor connector, they all seem to be 5mm?

6mm is much better than 5mm, less vibration

[crabstick]

Quote the comments of Jason the Admin @ HK :

Jason5001 (1347 points) 3/05/2010
FYI, TURNIGY outsorced the design and manufacture of this motor to the same factory that makes HACKER motors.

[crabstick]

Got this motor today. looks to be very large and well constructed, I cannot fault it visually.



Uploaded with ImageShack.us

[andym]

Looks cool, Turnigy are labeling some good gear at the moment. I am using their digital servos in all my boats. They have a high torque normal size that I have replaced the 1/4 size servo on the rudder in my gasser and it works faultless !!

[RayR]

Got this motor today. looks to be very large and well constructed, I cannot fault it visually.



Uploaded with ImageShack.us

Matt,

Could you please measure the mounting hole dimension on the motor. I have purchased 2 for a twin cat I am preparing.

Thanks you,

Ray

[crabstick]

Matt,

Could you please measure the mounting hole dimension on the motor. I have purchased 2 for a twin cat I am preparing.

Thanks you,

Ray

Hi Ray, I checked this last night and they are 24mm from center to center according to my verniers

[Meniscus]

Just an observation, but those motor wires look fairly light. Do they have the gauge printed on them?

[crabstick]

they do look a little thin, but they are very solid as in hard to bend. I think due to the low amp draw that these motors are known to have they should be ok.