seaking 180 timing

[Gen]

guys the defult setting for the seaking 180 esc timing is 15.00 is this ok with 4s in a cat with 2100kv ? ,as i know in my cars the timing is always very low or 0 or your temps are thru the roof ,,please explain ??

[sailr]

What MOTOR? Feigao? Neu? Leopard? etc? That is what determines where you want the timing set.

[Gen]

feigao 2073 kv

[57burb]

I'm also interested to know. I have a Neu 1515 1Y. I've run it at 18* and 22* but it doesn't seem to be any faster than at 15*. But the run times are shorter and temps are MUCH warmer with the higher advance settings. Thanks.

[Diesel6401]

feigao 2073 kv

Try 7.5*

I'm also interested to know. I have a Neu 1515 1Y. I've run it at 18* and 22* but it doesn't seem to be any faster than at 15*. But the run times are shorter and temps are MUCH warmer with the higher advance settings. Thanks.

I would keep at 15*

[sailr]

I would run that motor around 10-12 degrees.

feigao 2073 kv

[sailr]

Too high. Some run that motor at ZERO-5 degrees. 15 degrees is as far as you want to go. The higher the timing, the shorter the runs and the temps go up.
I run the 1515 1Y at 8-10 degrees

This is direct from Steve Neu:

Suggested controller settings when using the CC125 and CC180 controller.

Set cutoff to 4 volts (option 2)

Disable current limit (option 5)

Brake type: Hard brake, no delay (option 4)

Throttle type: Fixed throttle (option 2)

Advance: Low advance timing (option 3)

Cutoff Type: Soft cutoff (option 2)

Soft Start: Fast start (option 3)

PWM Switching Rate: 13 kHz (option 1)

I'm also interested to know. I have a Neu 1515 1Y. I've run it at 18* and 22* but it doesn't seem to be any faster than at 15*. But the run times are shorter and temps are MUCH warmer with the higher advance settings. Thanks.