Swordfish 240HV procedure

[T.S.Davis]

Okay, here I am again trying to make a SW fire. Not very optimistic but I'll ask again.

What is the procedure to arm/calibrate a Swordfish ESC?

[wuzofoz]

i only have 220amp pro version. not sure if the same.
to calibrate hold at full throttle and power up esc. you will have a tune then 4 single beeps. during those 4 beeps return trigger to middle and you'll get last beeps.
to arm i just plug in and give a little blip on throttle after it beeps

hope this helps
wuz

[T.S.Davis]

Thanks. I finally did figure it out. Tried it on a 120 too. Now just need to see if it works.

[oscarel]

http://www.hifei.com/#!swordfish-esc/cidm