Hifei Swordfish 240 amp

[jjrctech]

HI

I have a Hifei Swordfish 240 amp conneted to a Leopard 5692 Motor

I put everything in receier and batteries and the esc turn on but does not work?

And idea?

http://s1218.photobucket.com/albums/dd412/Jr_Jose1/

[IMG][/IMG]


Thanks

[oscarel]

Are you able to program iit?

[Alexgar]

calibrate the throttle

[Alexgar]

may need to rev throttle channel also(futaba)

[Alexgar]

also youll need a reciver pack for that esc

[jjrctech]

may need to rev throttle channel also(futaba)

Yes it a futaba)


and the its does have batteries on the esc and the receiver

[Alexgar]

rev the throttle channel and try and calibrate it does it make any noise when you plug it in

[Alexgar]

here are the instructions if you dont have them

http://www.astecmodels.co.uk/pdfs/Swordfish%20200A%20ESC.pdf

[oscarel]

See 112 and 115 http://forums.offshoreelectrics.com/...aba#post179370

[jjrctech]

the only way I have been able to calibrate it is with it full throttle and then full reverse to stop , I would like to only have to use the throttle ??

Thanks

[jjrctech]

got it to work , but the Esc should not turn red at full throttle should it??

what should the Pwm 8khz or 12 , or 16 ?? in the program?


Thanks

[Alexgar]

i have the 120 and i never even noticed an led

[jjrctech]

leds on are on the bottom if esc , what i like to know if how to tell if the motor is reaching top rpm correctly? 5692 I have make a very quiet

Thanks

[K.R.Joye]

Your short shrunk leads off the ESC motor end are scarin the heck out of me. Please insulate your connectors before the fire works go off.