Mamba XL X

[RandyatBBY]

Some times the cheap ESC can be used for light duty. Case in point I have the new Whiplash with a Pro Boat 1500Kv and a 52MM aluminum Prop. I added the 10 Capisitor capbank I build to the setup and have been running flawlessly. Now I would not trust this to a real full Psetup or a hot P LTD setup. I am running the CoolRC 90Amp ESC the low prifile made it work in my boat. Later in the year I will replace with a MGM when I can afford it.

[Speedfreek]

Here are two i have converted for mine but haven't used them yet still building my Mystic 138.
20180524_104734.jpg
Used the silicon conformal coating to water proof the board, see how it goes, i have used the XLX in a Slash 4x4 speed rig and went up to 378 amps
and i love the data loging it is very easy to use

[dasboata]

we have gotten 330 -350 amps on 8s,,, out of our XLX in cars ,,, The XLX is a way better esc , then the XL2

[dasboata]

Here are two i have converted for mine but haven't used them yet still building my Mystic 138.
[ATTACH=CONFIG]161106[/ATTACH]
Used the silicon conformal coating to water proof the board see how it goes, i have used the XLX in a Slash 4x4 speed rig and went up to 378 amps
and i love the data loging it is very easy to use

Man I like that !!!!

[Raydee]

Yeah they came out great. My buddy machined some plates for our Egde 200's and it made a huge difference in esc temp.

Sent from my SM-N950U using Tapatalk

[MG1234]

Those are cool ,what about cap banks? Needed on those?

[MG1234]

Does your buddy have a CNC machine he can scan those plates and crank out some more?

[Raydee]

I have never run a cap pack and so far I haven't needed them. I always check my ripple current and it's always been pretty low.

My buddy did these on a small machine and we are looking to do a small run but I doubt he will sell them.

Sent from my SM-N950U using Tapatalk

[Speedfreek]

Man I like that !!!!

Thanks ,if a 40mm fan can cool this the water cooling will definitely make it a ice machine

[Speedfreek]

Yeah they came out great. My buddy machined some plates for our Egde 200's and it made a huge difference in esc temp.

Sent from my SM-N950U using Tapatalk

That will work no problem and make it more compact as well, i have ample room in my 138 so i just milled the fins out and set the cooling blocks in ..
Looking sweet