Charging multiple lipos in series using Accucel 6 charger?

[ms71171]

I bought one of these to charge 2 3s lipos at once, but the connector for the balancing board does not fit mu Accucel 6 charger. http://www.helidirect.com/bantam-mul...pb6-p-7595.hdx

Anyone charged multiple lipos using an Accucell 6? If so, could you post a link for the balancing board that is correct?

The Accucel has a 7 pin and the balancing board had 8 pin.

[osprey21]

What brand batteries are you trying to charge?

[ms71171]

I'll be charging:

2 - 2S 20C 5000mah Turnigy
2 - 3S 40C 5000mah Turnigy
2 - 3S 25C 2200 mah Turnigy

I just ordered a Turnigy Accucell 8150 charger and I've read on here that the connector will work on this charger and it is an all around better charger at 150w.

[LiPo Power]

check this out:

http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=11170

[LarrysDrifter]

Thats sweet.I gotta have one of those!

[LiPo Power]

I Love it!!!
http://forums.offshoreelectrics.com/...ad.php?t=14737

Thats sweet.I gotta have one of those!

[wizard122]

This is what I did

I bought one of these to charge 2 3s lipos at once, but the connector for the balancing board does not fit mu Accucel 6 charger. http://www.helidirect.com/bantam-mul...pb6-p-7595.hdx

Anyone charged multiple lipos using an Accucell 6? If so, could you post a link for the balancing board that is correct?

The Accucel has a 7 pin and the balancing board had 8 pin.

Remove outside black wire and trim connector works great
http://forums.offshoreelectrics.com/...1&postcount=14

[ms71171]

Thank you for the replies. I went ahead and upgraded to the Turnigy 8150. I think it has the 8 pin. If not, I'll remove the black wire.

[wizard122]

The wire

Thank you for the replies. I went ahead and upgraded to the Turnigy 8150. I think it has the 8 pin. If not, I'll remove the black wire.

The wire I said to cut is not hooked up to anything its there for no reason except so it will only fit a Bantam charger ohm it out if you want to. Please look at my whole thread I use the same one with my 8150 and my BC6