How I made a 3p battery harness.

[rearwheelin]

Using 8 gauge , 6.5mm and 8mm bullets.

First I tie then tin.
image.jpg


Then I trim a notch for the bullet to go in.
image.jpg

I solder using only this method. http://youtu.be/l_DY7YjKdZ0

image.jpg

image.jpg

image.jpg

[Make-a-Wake]

Not sure what kind of harness that is, looks like a 3 cell SERIES connector. so if you are running 3s lipo(as an example) you would be running 9s.............I think, it looks very unique...........but not like parallel

[rearwheelin]

It is for hooking them up in parallel for my Team Believer ! I should have made it clearer in the OP ! My bad I mainly wanted to show how easy it is to join 8 gauge and bullets using a torch .

[Make-a-Wake]

Your soldering and creating skills are very good but it still seems like it will not work in parallel.................it looks like a series connector. Maybe someone else will post.................maybe im nuts.................

[rearwheelin]

Your soldering and creating skills are very good but it still seems like it will not work in parallel.................it looks like a series connector. Maybe someone else will post.................maybe im nuts.................

I suppose I could series the packs first and then plug into the harness, that would work !

[rearwheelin]

This pic is better. You can plug 1-3 matched packs anywhere on the harness !
image.jpg