hey, i was just looking into this what did you do for a coupler?
-
-
Probably a brass tube with the ID of the flex cable (an airplane pushrod btw), which appears to be the same as the motor, soldered to the brass and connected to the motor shaft with a set screw collar.Comment
-
ok cool
off to the lhs tomorow shall i go!
JamesComment
-
Use a collet with an ID of the brass tube size, and dremel a slot through the tube so the collet set screw rests on the shaft. The smaller the hole the better.
JonComment
-
Nice! In Hawaii everything grows greener
If all of your wishes are granted, many of your dreams will be destroyed!Comment
-
Years ago, this was build by a German guy with very small fingers :Comment
-
Not so fast. Im not there yet!Originally posted by Jesse J View Post
Seriously though. Cool build.
Years ago I built a 9" mono from a cut down Ned Schmidt abs mono. It ran like a skipping stone.Comment
-
Cool build!!
I am really getting into the smaller boat builds, the learning curve is not as expensive, and there are a lot of smaller ponds that they can be run in.
Can't wait to see more of this boat.There is a fine line between "hobby" and "mental illness."Comment
Comment