Mhz mystic 114 build

[BUMBLESPECIMOODA]

CONTINUED...

139.JPG 140.JPG

After the dunk-test fully equiped, it will be revealed if more floatation is needed. There's plenty of realestate between the cowl and the bridgedeck. One of the reasons why I did not mount the ESC's etc. there. I can put a huge chunk of foam there.

[fweasel]

Hard to tell without the canopy opening in place for reference, but I hope you've left yourself enough room for the batteries to be slid forward.

[BUMBLESPECIMOODA]

Lots of room. With 6500mAh packs (the biggest I think I'll be using), cg tested good with them as far back as I could get them, without touching the ESC's. With smaller packs like 5000mAh, lots of room for sliding to front.

BTW folks, I found a perfect spot for running these wee boats. Having done that, I'm going nuts not to be able to go play with them. Might have to get a ready to run ProBoat or something, to take care of the wait.

[BUMBLESPECIMOODA]

Water pick-up tubes ready:

143.JPG 144.JPG 145.JPG

[fweasel]

Where did you source the small diameter carbon braid? I've been looking for something like that to do exactly that same waterline wrap.

[BUMBLESPECIMOODA]

Where did you source the small diameter carbon braid? I've been looking for something like that to do exactly that same waterline wrap.

ALIEXPRESS.

It was 4mm ID.

[fweasel]

Thanks!

[BUMBLESPECIMOODA]

Pick-up tubes ready. Barbs made from mud. They will be installed through the hull tonight. Pics to follow.

146.JPG 147.JPG 148.JPG 149.JPG

[fweasel]

I love the silicone hose form used for the barbs. Great idea.

[BUMBLESPECIMOODA]

I love the silicone hose form used for the barbs. Great idea.

I saw a fella using pieces in place of zipties, on another thread. It gave me the idea for the mudding template.

[BUMBLESPECIMOODA]

Started on some hatches. One will be to vent the front sealed section, and the rear one to possible do something...

B.JPG C.JPG D.JPG E.JPG F.JPG

[BUMBLESPECIMOODA]

Cont...

G.JPG H.JPG J.JPG J.JPG

[mmars89]

Absolutely beautiful and inspiring work my friend. Wow. Following.

I'm about to start a Mystic 114 build, thanks for sharing!

Cheers

[Alfa Spirit]

Tried a slick coat of clear on the scoops too. Nect will be the bandit mask and the carbon rudder parts.

[ATTACH=CONFIG]179241[/ATTACH]

I think that with the black grids it would be much more realistic.

[BUMBLESPECIMOODA]

Absolutely beautiful and inspiring work my friend. Wow. Following.

I'm about to start a Mystic 114 build, thanks for sharing!

Cheers

I will be happy to follow your build as well.

I think that with the black grids it would be much more realistic.

I might just do that.