New 45" Keith Bradley/Radtek Cat Hull

[srislash]

What ya Think?[ATTACH=CONFIG]119570[/ATTACH][ATTACH=CONFIG]119571[/ATTACH][ATTACH=CONFIG]119572[/ATTACH][ATTACH=CONFIG]119573[/ATTACH]

Those certainly look a bit big on that hull. Which ones are they? MHZ?

[flraptor07]

They are these, scroll down this page. http://kintecracing.com/Accessories.html

[flraptor07]

KB 45" on it's Maiden Voyage

Here the KB 45 on it's Maiden Voyage, got some steering issues but it ran nice and those Pysclone Hobbies 4474s seem to run nice too!

https://www.youtube.com/watch?v=iT7Xe83fcFw

[Apophis]

Awesome man! Looks to be running great for a maiden!

[Vin-m]

really nice boat chris. glad i got to see her in person wish i was a little earlier to see the run .

[keithbradley]

Looks like it runs pretty good, but it looks like that large rudder blade has no problem tossing her around if the input is too great. Perhaps adding some steering expo would help.

[flraptor07]

Looks like it runs pretty good, but it looks like that large rudder blade has no problem tossing her around if the input is too great. Perhaps adding some steering expo would help.

LOL yeah I had Expo @ 45% and still did that. I'm gonna be making that blade narrower, today was with a inch off the length.

[Ken_NJ]

Look like it runs great, fast, minor troubles at the turns. Teething troubles. With boats like these I would think there would be some problems, you saw mine. Be glad its not an airplane or heli, bad results there.

[iridebikes247]

nice job man, looks to be running good.

[Chrisg81983]

LOL yeah I had Expo @ 45% and still did that. I'm gonna be making that blade narrower, today was with a inch off the length.

Looks good man definitely need some blade cut off. You will probably end up with about 3.5 inches of blade hanging below tunnel

[flraptor07]

Looks good man definitely need some blade cut off. You will probably end up with about 3.5 inches of blade hanging below tunnel

That's about where I'm at now with length, now I've got to make it narrower by about half.

[kfxguy]

What radio are you running?

[flraptor07]

What radio are you running?

It's the new Spektrum DX4R Pro with a MR3000 marine Rx and I already know what your gonna say "Put both antennas outside the hull"

[kfxguy]

It's the new Spektrum DX4R Pro with a MR3000 marine Rx and I already know what your gonna say "Put both antennas outside the hull"

Yep....lol...report back after you do.

[twissted]

This build reminds me of the RCMK 1200 hull boats. I say this because of the larger rudder base that you get with that hull. That I like very much as I like to build a saddle for my rudder to fit in. I would change the hull also if I was to use this hull.
I like both the RCMK 1200 hull and this hull. Both have there strong points!
Keith you have both hulls. what is the weight differance?