Nitro Elam conversion

[Heaving Earth]

Ok I see. I noticed that you can get batteries in the sponsons, but there's no way of holding them down. I wonder if you dig out an opening in the foam maybe you can get them in there

[srislash]

Yup,I'll have to get the flexi-dremal out and try. Perhaps a set of 3s 3300 Dynogy's will squeeze in there.I've been building the GF a new hair salon so the boats have been neglected.But it(salon) is done. I'll try to size it up later on.
And here is the vid http://www.youtube.com/watch?v=xbB4J...=youtube_gdata

[Heaving Earth]

Man, you must have the best hair....

[Heaving Earth]

Boat looks decent

[srislash]

Notice the flutter though,that is a X637 on it.And Sirius 1512 2650kv/SK-180 in it.

[Heaving Earth]

Yeah there's a bit of flutter there. But not too bad. I think if you can get the weight up a bit you'll be good to go

[Heaving Earth]

Got to lay some carbon on the floor today. ImageUploadedByTapatalk1367693774.311576.jpg

[jim82]

Looking good!

[Heaving Earth]

Thanks man

[SloHD]

Looks very good. I'm about to embark on the same endeavor. Keeping an eye on this build.

[Heaving Earth]

Glad to see others are interested in doing stuff with these hulls still. I figured nobody would have interest in these things, ESpecially going thru the work I've been doing. Hope it's all worth it in the end -)

[Heaving Earth]

Got the stuffing tube in. I did a float test and no leaks. The floor is significantly stiffer now. ImageUploadedByTapatalk1367719114.229687.jpgImageUploadedByTapatalk1367719134.092160.jpg

[Heaving Earth]

ImageUploadedByTapatalk1367726600.958328.jpg
I'm still Trying to improve my skills laying carbon weave. It was rather tricky in this hull but I think it's ok.

[Brushless55]

looks good!

[srislash]

Glad to see others are interested in doing stuff with these hulls still. I figured nobody would have interest in these things, ESpecially going thru the work I've been doing. Hope it's all worth it in the end -)

I think there may have been some lurkers in the hydro section,I took a few pokes at getting advice about the Bud to no avail. Really glad to see some happening going on here. Nice work thus far.