Delta Force 26 Rebuild

[MAMBA2200]

So im finally starting to get some parts in for my DF26 figured i would post up some pics of what ive done so far
adf1.jpgadf2.jpgadf3.jpgadf4.jpg

[MAMBA2200]

painted on the windshield and a little on the hull adf5.jpg

[Heaving Earth]

Nice boat

[MAMBA2200]

Thanks

[785boats]

Good one.
I love watching these little hulls get built. There's so many different setups. They can handle so many different power systems.

[MAMBA2200]

thanks i cannot wait to get this one wet it should be a screaming deamon

[MAMBA2200]

got the servo mount in hope the rest of the parts will be in this afternoonadf6.jpg

[MAMBA2200]

motor and esc installed adf7.jpg

[MAMBA2200]

Well its finally ready to get wet got everything done rudder is on and water cooling lines installed adf8.jpgadf9.jpg

[785boats]

Good to see Mamba.

Before you take it for a run, can I offer a couple of suggestions?
It would be best if you cut those ties on the motor to ESC connectors & spread the connectors apart. They are creating a hot spot. I've seen heat shrink melt & bullets short out.
I would replace the bullet nut on the prop shaft with a Nylock nut. The bullet nut usually spins off & the prop ends up on the bottom of the lake unless you put some locktite on the thread.

Looking forward to the maiden. I hope all goes well.

Paul.

[dannybj26]

Hey MAMBA what rudder is that ? I need one for my 26 bling

-Danny

[MAMBA2200]

man i could not tell you i bought it from the guy i bought my boat from i think he said it came from hobbyking but im not sure

[dannybj26]

What rudder would you recomend for this boat

-Danny

[MAMBA2200]

to be honest i looked at allot and didnt find one i liked maybe someone will chime in and offer a suggestion but then again you could go this way http://www.offshoreelectrics.com/pro...t-oc6str-130da

[Basstronics]

Holy smokes... will it run good with the prop that high up???