Bullwink's EKOS twin

[Bullwink]

Here is a short video of my Keith Bradley EKOS. I'[m not sure what happened at the end. It looks like I hit something.

http://youtu.be/858xumKfISw

[keithbradley]

Cool! Yes that was a weird flip at the end of the vid. It was tough to tell why it flipped though from that distance. It looks great though and you have to love that sound of twin outrunners!
If you want any Keith Bradley Boats decals for the ESC plate let me know. I have been putting them on recent builds and they really look great.

180-190 is really high for temps after 2 minutes. They shouldn't be getting that hot with your setup. What are you setting the timing at? I would definitely experiment with the timing to see what lowers temps. A lot of people say to run high timing on outrunners but I had good results with 5 degrees on these outrunners. I think ESCs may vary also so don't go 100% by what someone else says works for them.

[Bullwink]

I fixed the motor temp problem. I think I did not have enough distance between the drive dog and stinger. They were at 119 after a two minute run. I have the timing set on Auto. The Swords only give you Auto, Low, Med and High on timing.

[Rich]

Can you tell me what stingers you used? I am looking for some that will take a 3/16" prop shaft, and if you could tell me what rudder you used that would be great! I love the carbon fiber you are and artist!

[keithbradley]

They were 4mm stingers that were bore out to .187". Are you looking for stingers for an EKOS or something different?

The rudder was a 115mm I believe, sold here at OSE.

[Rich]

I am looking for the ekos, I want to upgrade my brothers to 3/16.