Got the hull last fall finally getting around to finishing it up for the first club race in April got the radio box built hardware mounted up now i just need to seal the hull and install the electronics and do some testing. I have one problem in a couple of small spots were i used some epoxy resin it is not drying it's been a couple of days now and the spots are still tacky any ideas guys on how to fix or what to use to remove from the spots . Also any suggestions on props and out drive depth i will be using a ul-1 motor 4s 1p 5000s 40c hopefully be ready to test next week
-
-
Looks good Tony... Your in better shape than I am right now. Try hitting the soft spots with a hair dryer or some place warm.
Later
Mike -
42x55 detounged is what some people have had success with.Comment
-
Well finally got my VS-1 done today painted the cowl & resealed the hull the other day and got the hardware & electronics mounted today hopefully I will make it to the pond Monday for club test & tune day. Think she came out OK for my first build I have two more builds to get done for the race season hope they go a little faster than this one did.Comment
-
Looks good T! I gotta get hump'n on mine... As a matter of fact, I should be down there now!
Later
MikeComment
-
Thanks Mike I gotta get going on my Q sport need to get that done before the first race & the 10th scale needs to be finish to but thats really going slow got to stop racing the 1/8 scale car and get going on my boatsComment
-
I let the dogs out...Comment
-
E-bay just type in red bull stickers on a search and you will find them I think it was like 12 dollars for 5 sheets of stickers the guy is out of TaiwanComment
Comment