Just for Fun

[j.m.]

I wouldn't be surprised if you had trouble with cavitation from an air pocket forming just behind the water intake...

[F1 madness]

Iv made some alterations moving the strudder unit up abit and reinforced the rear.

[ozzie-crawl]

i still say turn it around,looks like it maybe a universal strut.

[F1 madness]

i still say turn it around,looks like it maybe a universal strut.

Alrite bud the stub shaft and flexi drive should be here this week,when it turns up im gonna try before i continue,but for now just gotta wait again,but on another note the lite-ply has come now so can continue with the F1 build

[F1 madness]

Alrite guys been off for while internet beens down,but id thought id post some pics of the finished build,not quite running yet but wont be long now






Hope you like

[j.m.]

What hardware did you use???!?

That's the first time i've seen a conventional mono stinger on a hydro. Rudder looks nice!



EDIT:

Oh, hah!! I just scrolled up the page and saw your setup... :P

Jon

[F1 madness]

What hardware did you use???!?

That's the first time i've seen a conventional mono stinger on a hydro. Rudder looks nice!



EDIT:

Oh, hah!! I just scrolled up the page and saw your setup... :P

Jon

LOL thinking of turning the strut round,but abit of work is required but shouldnt be to hard

[Jeepers]

LOL thinking of turning the strut round,but abit of work is required but shouldnt be to hard

nice build!!!!! your struts backwards the knife edge goes to the front.

[F1 madness]

nice build!!!!! your struts backwards the knife edge goes to the front.

Cheers mate glad you like
I thought that when i brought it but tried it the other way round and the the stub shaft was to short to get prop on but plenty the way it is now,so what im planning is pressing out the centre bushing and turning it round,like iv done on my F1 hydrofighter build take a peak at build thread and youll see what i mean.

[F1 madness]

This boat is now forsale if interested pm me