32 in aeromarine jersey skiff

[HydroMike]

OK thanks doug will do

[Doug Smock]

OK will do thanks guys. What temps do I need to try to keep on the UL-1?

Mike put the same profile on the X442 that I put on that 445 for you. Keep your temps under 140'F and you're equipment will thank you.

[ron1950]

i always try to use a general rule oif thumb....if its too hot to hold your fingers to it for any lenmth of time its too hot.....or about 120 to 130 i think max....maybe tony can way in on the actual temps...

[HydroMike]

OK will do thanks guys. What temps do I need to try to keep on the UL-1?

[properchopper]

try a back cut 442 it keeps mine nice and cool

[ron1950]

try a back cut 442 it keeps mine nice and cool

[HydroMike]

I was told to keep it around 200 thanks Doug hope it didn't hurt it ran two runs will see next outing

[Doug Smock]

Mike you start loosing magnets at approx 180'F.
I try to keep my motors and ESCs at or below 135.
Try a M cut x442 on that boat. That's what we ran in SOWEGA last year.

[HydroMike]

Tony I had to cut them down a little was a little much but I'm holding about 200 deg. In 60 deg. weather I'm sure it will need a little more when summer rolls around. When I get back out going to try a 440 to see how that does too

[properchopper]

Tony where did u get ur drivers ?

http://www.insaneboats.com/mm5/merchant.mvc?Store_Code=insane&Screen=PROD&Category_Code=Hull-Accessories&Product_Code=Thunderboatdriverunpainted

http://www.insaneboats.com/mm5/merchant.mvc?Store_Code=insane&Screen=PROD&Category_Code=Hull-Accessories&Product_Code=ThunderboatdriverPainted

These are the only drivers I found that are "right-sized". Got the unpainted ones, bought a Testors paint kit for $11 & had some fun.

How's the heat with the M445 & 2030 ? Are you running a submerged prop ?

[ron1950]

dont know where he got his but hangar 9 has alot of drivers in different scales

[HydroMike]

Tony where did u get ur drivers ?

[HydroMike]

M445 on 4s

[properchopper]

I have the UL-1 in mine runs great

May I inquire which prop you're using with the 2030 motor ?

[ron1950]

ive thought about the 2030 but went with the more torquey 1800 motor...would be fun to see if the 2030 can push these tubs faster lol