fightercat esc questions

[driftah]

16s/200 yes they are soldered directly to the board...I may just fill the bullets with solder and drop wires in of my own.

[srislash]

Driftah;
which ESC is it please?

thanks

Ahhh,good point Carl. Some of them have bullets on the board. My bad, I apologize .

[carlcisneros]

Driftah;
which ESC is it please?

thanks

[Alexgar]

Hobbyking sells 6mm plugs I use them on all my higher amp setups

[srislash]

No no,not solder to the board. Just undo the 6's and put yours on the wire leads.

[driftah]

so you are saying to cut back the shrink and solder my 8mm bullets to the board on this esc? here we only have 5.5 or 6.5 bullets and I think the ones on it are 6mm.....odd kinda but it is a china esc afterall lol

[srislash]

You would not have any bullits available to you??? Just desolder them and but yours on.Much cleaner than adding wire.
I run 5.5mm on motor side for most all my rigs.6.5 Castle's on battery side.

[driftah]

and are these esc setup w 6mm bullets on the motor output side? not likely for me to find any so shall I just fill cups w solder and drop a heavy guage wire in there? who has done this sofar and results...

[driftah]

ok its firmware update plug nm

[driftah]

just recd. a fightercat esc and wondering what the 4 pin receiver style plug does? wondered also why the cap bank that comes with these escs has 8 guage wire lol.....maybe overkill haha