Charge Rate

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • 785boats
    replied
    Lone wolf.
    There is a wealth of information at the 'Battery University'. If you read this page AND all the topics in the menu down the left side of the page, you will learn a lot about batteries.
    Manufacturers take a conservative approach and specify the life of Li-ion in most consumer products as being between 300 and 500 discharge/charge cycles.…


    Back to school with you.
    There will be a written exam at the end of the week.

    Leave a comment:


  • mappo
    replied
    Originally posted by kfxguy View Post
    Man I'm scared. Scared to charge over 1c. I'd rather wait than be sorry. That's how I roll. It's not worth it to me in my opinion. All my Batts balance perfectly.
    I have been charging my 5000 mah lipos at 8 amps 1.6c
    for a very long time even when the manufactures recommend 5c
    For storing my lipos I use 50-60% and never more than a few days fully charged, I had 3 packs puffed after a few days at 95% charged

    Leave a comment:


  • Brushless55
    replied
    Originally posted by kingwrench View Post
    I have found that when I use my good charger with my 24v power supply I charge @ 5c. Battery s stay ccool and nice clean quick charge. IMO buy a great charger,great battery's,and a kick ass power supply. Buy the best and only cry once. Charge in 1\4 the time it takes others. I charge 6 (6s) battery's at the same time and it takes 25 to 35 min :-)
    That is something I need is a more powerful charger

    Leave a comment:


  • lonewolf
    replied
    this is for G UNIT in short 1 c equals the mah of cell in your case 5000 = 5amps or one c 2c= 10 amps.... I recently purchased a bunch of lipos and have been doing alot of reading on break in and such of lipos many recommend a easy break in of less than or equal to one c for 3-5 cycles...then a few easy runs with easy charges....after that charge as you want....or as recomended....for my 3s cells I am cycling at 1c just down to 30% with full charges.... Am I correct in this sure hope so...I have also called apon a fellow racer here who advises the same.... He must be doing something right cuz he has quite a few records....I hope this helps someone......

    I was hoping to find a sticky about lipos care and chargeing/discharging..... After a night of reading I am finding there are almost to many variables to actually set "rules" between brands and manufacturer recomendations it seems advice is all over the spectrum.... ???? I dont have the greatest of anything so I just take it easy on my euqipment...good luck to all!!

    Leave a comment:


  • kingwrench
    replied
    I have found that when I use my good charger with my 24v power supply I charge @ 5c. Battery s stay ccool and nice clean quick charge. IMO buy a great charger,great battery's,and a kick ass power supply. Buy the best and only cry once. Charge in 1\4 the time it takes others. I charge 6 (6s) battery's at the same time and it takes 25 to 35 min :-)

    Leave a comment:


  • Brushless55
    replied
    Originally posted by runzwithsizorz View Post
    As a rule of thumb, I usually charge at 1 amp less then what the specs say I can get away with, especially for cheaper batteries. I use the 2s Turnigy nanotech 5000mah 45c, and sometimes will charge at the full 5 amps. My Hyperion charger IF left on auto would charge your batteries at 5amps but the last 15, or 20 minutes it throttles back to less than an 1amp, does your charger do this? Most everyone will tell you that slower is better.
    several of the Thunder Power plane guys love and preach on charging at 10-12C on those packs because they like to sell the only need one or two packs to fly all day motto...
    but I prefer 1-3C depending on what packs I am charging

    Leave a comment:


  • runzwithsizorz
    replied
    Originally posted by G-UNIT View Post
    Yes but c2 is equal to what amp should I charge at 1 amp, 4 amp, 5amp ect.
    As a rule of thumb, I usually charge at 1 amp less then what the specs say I can get away with, especially for cheaper batteries. I use the 2s Turnigy nanotech 5000mah 45c, and sometimes will charge at the full 5 amps. My Hyperion charger IF left on auto would charge your batteries at 5amps but the last 15, or 20 minutes it throttles back to less than an 1amp, does your charger do this? Most everyone will tell you that slower is better.

    Leave a comment:


  • Brushless55
    replied
    Originally posted by G-UNIT View Post
    I don't mean to bud in here but I always get confuzed on this 1c thing, I use turnigy 5000 2s1p mah and charge tham at 4-5 amps, is takes about an hour.
    can someone go over 1c = what ect...
    Originally posted by G-UNIT View Post
    Yes but c2 is equal to what amp should I charge at 1 amp, 4 amp, 5amp ect.
    G-UNIT I got ya buddy...
    2C would = 10amps
    5000mah pack charged at a 1C rating is 5amps
    6000mah pack charged at a 1C rating is 6amps
    7500mah pack charged at a 1C rating is 7.5amps
    etc

    Leave a comment:


  • rickwess
    replied
    Originally posted by G-UNIT View Post
    Yes but c2 is equal to what amp should I charge at 1 amp, 4 amp, 5amp ect.
    "C" = the capacity of the battery. So for a 4400mah battery, the 1C charge rate is 4400ma.

    Leave a comment:


  • G-UNIT
    replied
    Yes but c2 is equal to what amp should I charge at 1 amp, 4 amp, 5amp ect.

    Leave a comment:


  • Doug Smock
    replied
    Hey Robert,
    Follow the manufactures instructions for the best results.
    This is from HK on the Turnigy 5000 30c 2s packs.

    Capacity(mAh) 5000
    Config(s) 2
    Discharge(c) 30
    Weight(g) 301
    Max Charge Rate (C) 2
    Length-A(mm) 143
    Height-B(mm) 50
    Width-C(mm) 19

    Leave a comment:


  • G-UNIT
    replied
    I don't mean to bud in here but I always get confuzed on this 1c thing, I use turnigy 5000 2s1p mah and charge tham at 4-5 amps, is takes about an hour.
    can someone go over 1c = what ect...

    Leave a comment:


  • Doug Smock
    replied

    Do some reading on capacity loss fellas.
    I'm going to go practice peeing up a rope.

    Later...........

    Leave a comment:


  • Brushless55
    replied
    Originally posted by kfxguy View Post
    Man I'm scared. Scared to charge over 1c. I'd rather wait than be sorry. That's how I roll. It's not worth it to me in my opinion. All my Batts balance perfectly.
    never a bad thing to charge at 1C


    Originally posted by kfxguy View Post
    I always put my packs in storage mode immediately after use. Just funny about it I guess.
    usually Sunday after I get home from a race I start putting my packs into storage charge...
    but some sit for several days depending on how busy I get around the house and at work

    Leave a comment:


  • Brushless55
    replied
    Originally posted by Brushless55 View Post
    uh broad brush..... 2-3 weeks or was that 2-3 weeks

    Doug I want to personally invite you to the High Altitude Shootout that my friend and I are putting on
    you can run one of my freshly charge erh uh make that my 3 week charged lipo and see how she does
    https://www.facebook.com/MileHighMod...17226264982870
    This is our club
    https://www.facebook.com/MileHighModelers

    and our facebook page we over see
    https://www.facebook.com/groups/690269474349798/

    We belong to Namba20 and really want to take D20 higher and bring the family fun factor for all ages!
    Originally posted by Doug Smock View Post
    Which is it Todd???

    Never mind, we have a clear understanding now. lol

    Thanks for clearing that up.

    Driving on now.
    let me try this again....
    I will charge up a few packs 3 weeks before the High Altitude Shootout and leave them charge up just for you to try out and see they don't melt down during a 6 lap heat

    Leave a comment:

Working...